Table of Contents
Advertisement
To add a secondary switch to an AutoView switch system:
NOTE: Cascading can only be done with CUFC, CIFC or CIFCA cables.
1.
Follow the steps in the procedure To install an AutoView 200/400 switch for
each cascaded unit.
2.
Plug the 25-pin D connector of your CIFCM input cable into any available
channel port on the rear of your primary AutoView unit.
3.
Plug the 15-pin video connector on the other end of the cable into the
port labeled
on your first cascading AutoView unit. Plug the PS/2 mouse
connector into the
connector into the
Powering Up the AutoView Switch System
Servers may be powered up one at a time or all at once. No operator
intervention is required during booting. As the system stabilizes, the green
LED over each channel will light, indicating that the attached server is
powered up.
port. Plug the remaining 6-pin miniDIN keyboard
port.
Chapter 2: Installation
17
Advertisement
Table of Contents
