Avocent AutoView 1000R Installer/User Manual page 19

To adjust the mouse acceleration:
Before a server can be connected to the AutoView 1000R/2000R, an adjustment to
mouse acceleration must be made. Use the default Microsoft
mouse driver for all attached Microsoft Windows systems attached to the appliance.
For Microsoft Windows NT
1. From the desktop, select Start - Settings - Control Panel - Mouse.
2. Click on the Motion tab.
3. Set the pointer speed to Slow. You will need to set this for any Windows NT user
account that will be accessing the Windows NT system through the appliance.
For Microsoft Windows 2000/Windows XP:
1. From the desktop, select Start - Settings - Control Panel - Mouse.
2. Click on the Motion tab.
3. Set the Acceleration setting to None and the speed setting to the default of 50%.
To connect an AVRIQ adaptor to each server:
1. Locate the AVRIQ adaptors for your AutoView 1000R/2000R unit.
2. Attach the appropriately color-coded cable ends to the keyboard, monitor and
mouse ports on the first server you will be connecting to the unit.
3. Attach one end of the CAT 5 cabling that will run between your AVRIQ and
AutoView unit to the RJ45 connector on the AVRIQ adaptor.
4. Connect the other end of the CAT 5 cable to the desired ARI port on the
back of your AutoView unit.
5. Repeat steps 2-4 for all servers you wish to attach.
NOTE: When connecting a Sun AVRIQ adaptor, you must use a multi-synch monitor to
accommodate Sun computers that support both VGA and synch-on-green or composite synch.
Chapter 2: Installation
(using default drivers):
®
13
Windows PS/2
® ®