Changing The Sanding Belts - Clarke WOODWORKER CS4-6D Operation & Maintenance Instructions Manual

CHANGING THE SANDING BELTS

CAUTION: CHECK THE INSIDE OF THE BELT FOR A "DIRECTION ARROW". IF
PRESENT, INSTALL THE BELT WITH THE ARROW POINTING IN THE SAME
DIRECTION AS THE DIRECTION INDICATOR ON THE HOUSING.
1. Loosen the socket head screw
using the 6 mm hex wrench
provided.
2. Raise the belt sanding arm as
shown.
3. Slide out one end of the tension
lever as shown to release belt
tension.
4. Remove the tray located on the
bottom of the belt sanding arm by
loosening the two screws on the
back of the belt sanding arm.
5. Slide the sanding belt off of the drive and idler drums.
6. Slide new sanding belt over the drive and idler drums. Ensure the belt is
centred on both drums and is the right way round.
7. Return the tension lever into its original positiom to apply tension to the belt.
8. Replace the tray and tighten the two screws on the back of the belt
sanding arm.
9. Lower the belt sanding arm and tighten the socket head screw using the
6mm hex wrench provided.
CONSUMABLES
Sanding Belts are available from your Clarke dealer.
Grit
Fine
Medium
Course
10. Before using, check belt tracking as described in the next section and
adjust as necessary.
Part number
6502096
6500808
6502101
10