Stihl BT 130 Manual page 111

1
2
: Push the lockout lever (1) onto
the pivot pin (2) and attach the
torsion spring's upper leg.
1
: The torsion spring (1) must
engage the notch (arrow).
2
: Attach the throttle cable (1) to the
trigger (2).
– Turn the throttle trigger 90°
counterclockwise.
– Push the handlebar home, line it
up and secure it position, b 10.1
44
1
: Push the throttle trigger (1) onto
the pivot pin (2).
1
: Position the throttle trigger (1) so
that the step on its lug (2)
engages the lockout lever
(arrow).
1
1
: Push the torsion spring (1) under
the throttle cable (2).
1
2
3
2
: Push the torsion spring (1) onto
The curved leg (arrow) must locate
on the peg (3).
2
: Push the slide (1) into its seat so
2
The protective tube (1) must be
properly seated in the convolutions
of the handle molding.
: Push the short circuit and ground
the pin (2) as far as stop.
1
that it engages the center of the
toothing (arrow).
1
wires into the guide (arrow), then
fit the protective tube (1).
BT 130