Dhw Heating - Viessmann Vitotronic 200 Operating Instructions Manual

DHW temperatures
Setting the standard DHW temperature
Factory setting: 50 °C
1. Extended menu:
2. "DHW"
Setting the higher DHW temperature
Factory setting: 60 °C
The DHW will be heated to the higher DHW tempera-
ture under the following circumstances:
In the time program for DHW heating, you have set a
■
time phase for the "Temp. 2" operating status: see
page 34.
■ You have activated once-only DHW heating: see
page 35.
You have activated manual mode: see page 56.
■
1. Extended menu:
Operating program
Further information can be found in chapter
"Terminology" in the appendix.
Setting the operating program for DHW heating
For the preferred heating/cooling circuit
1. Standard menu:
/ for the operating program:
e.g. "Only DHW"
2. OK to confirm
For further possible operating programs: see page 19.
For all heating/cooling circuits
1. Extended menu:
Time program
Further information can be found in chapter
"Terminology" in the appendix.
3. "Set DHW temperature"
4. Set the required value.
2. "DHW"
3. "Set DHW temperature 2"
4. Set the required value.
Note
Where necessary, enable the electric booster heater in
order to achieve the required DHW temperature: see
page 37.
2. "Heating" or "Heating/cooling"
3. If applicable, use / to select the required heating/
cooling circuit
4. "Operating program"
5. E.g. "Only DHW".
For further possible operating programs: see page 19.

DHW heating

33