Modifying and scanning time programs
DHW heating and DHW circulation pump
The time program for DHW heating and DHW circulation pump is set to
Automatic mode, i.e. the DHW heating operates parallel with the time
program, but starts 30 minutes earlier.
The DHW circulation pump operates parallel to the DHW heating time
program.
Should you not wish to operate in automatic mode, you can also set up
individual time programs.
If you want to heat DHW once outside the set time program, see page 13.
The following explains the setting up of a time program using DHW heating
as an example. Set up the DHW circulation pump time program in the same
way; also note the table on page 17.
Setting up automatic mode
(if necessary)
Press the following keys:
1. !, ? or §; the respective key
will then illuminate.
2. B
for "DHW time program".
3. a/b for "Automatic?", if
"Automatic?" is not already
displayed.
4. d
to confirm;
the display changes to that
of the boiler temperature.
20
Setting up an individual time
program
Press the following keys:
1. !, ? or §; the respective key
will then illuminate.
2. B
for "DHW time program".
Please note:
If you want to terminate setting up
a time program, press B again
and confirm with d.
3. a/b for "Individual?", if
"Individual?" is not already
displayed.
4. d
for confirmation.