Mercedes-Benz CLA Operator's Manual page 60

58 58 Occupant safety
O Always comply with the manufacturer's
installation and operating instructions for the
child restraint system used.
O Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
® When installing a LATCH-type (ISOFIX) child
restraint system, also observe the following:
O When using a bab When using a baby car seat in w y car seat in weight gr
0/0+ and a rearw 0/0+ and a r earwar ard-f d-facing c acing child r hild res estr traint
system in w syst em in weight gr eight group I on a r oup I on a rear seat ear seat: :
adjust the front seat so that the seat does
not touch the child restraint system.
O When using a f
When using a forw orwar ard-f d-facing c acing child r hild res estr traint
system in w syst em in weight gr eight group I: oup I: remove the head
restraint from the respective seat, if possible.
In addition, the backrest of the child restraint
system must lie as at as possible against
the backrest of the vehicle seat.
A er the child restraint system has been
removed, replace the head restraint immedi-
ately and adjust all head restraints correctly.
O If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle, this will result in restrictions on the
maximum size setting for child restraint sys-
tems in weight group II or III.
Contact with the roof when the head
restraint is fully extended and locked in place
will not result in any restrictions on use.
O The child restraint system must not be put
eight group oup
under strain between the roof and the seat
aint
cushion and/or be installed facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
O The child restraint system must not be put
aint
under strain by the head restraint. Adjust the
head restraints as appropriate.
1 LATCH-type (ISOFIX) mounting bracket
Before every journey, make sure that the
#
LATCH-type (ISOFIX) child restraint system is
correctly engaged in both mounting brackets
in the vehicle.