Mercedes-Benz CLA Operator's Manual page 326

324 Wheels and tires 324
%
V V ehicles wit ehicles with a tir h a tire pr e pressur essure loss w e loss war arning sy
t t em: em: If an emergency spare wheel is installed,
the tire pressure loss warning system cannot
function reliably. Only restart the system
again when the emergency spare wheel has
been replaced with a new wheel.
V V ehicles wit ehicles with a tir h a tire pr e pressur essure monit e monitor oring sy
t t em: em: If an emergency spare wheel is installed,
the tire pressure monitoring system cannot
function reliably. For a few minutes a er an
emergency spare wheel is installed, the sys-
tem may still display the tire pressure of the
removed wheel. Only restart the system again
when the emergency spare wheel has been
replaced with a new wheel.
Be sure to also observe the following further rela-
ted subjects:
Notes on tire pressure ( page 295)
/
R
Tire and Loading Information placard
R
( page 302)
/
Tire pressure table ( page 297)
R /
Notes on installing tires ( page 313)
/
R
Installing an emergency spare wheel
R
( page 318)
/
ning sys- s- In ating t t he emerg In ating he emergency spar ency spare wheel
* N N O O TE TE Overheating due to the tire in ation
compressor running too long
Do not run the tire in ation compressor
#
for longer than ten minutes without inter-
ing sys- s-
ruption.
R R eq equir uirements: ements:
Comply with the manufacturer's safety notes on
the sticker of the emergency spare wheel and on
the tire in ation compressor.
Remove the sticker with the label 50 mph
#
(80 km/h) from the tire in ation compressor
housing and a x it to the instrument cluster
within the driver's eld of vision.
Remove the tire in ation compressor from the
#
storage well under the trunk oor
( page 277).
/
e wheel
Pull ller hose
#
in ation compressor housing.
Insert plug
#
on the tire in ation compressor and then turn
it until plug
Unscrew the cap from the valve on the emer-
#
gency spare wheel.
Screw union nut
#
valve.
Make sure on and o switch
#
in ation compressor is set to 0 0 .
Insert plug
#
12 V socket (
R
1 and plug 3 out of the tire
7 of ller hose 1 in the socket
7 engages.
2 of ller hose 1 onto
4 of the tire
3 in a socket in your vehicle.
page 108)
/