Table of Contents
Advertisement
EchoStar Tri Control, Programmable Remote Control Unit
4.3. READ OUT THE EQUIPMENT CODE
NOTE
You can read out the code from the RCU, just blink back the code. It is handy for
future reference. Remember you only can blink back the code after the RCU
operates your device.
1.
Switch your TV to on and make sure a broadcast is seen.
2.
On the RCU, press the TV key continuously until the indicator stays on.
3.
Release the TV key and make sure the indicator blinks continuously.
4.
Use the numerical keys to enter code 9 9 0.
5.
Note that the indicator goes off and stays off.
NOTE
The amount of blinks gives you the first number, no blinks indicate a 0.
6.
Press the numerical key 1 and count the blinks for the first number.
7.
Press the numerical key 2 and count the blinks for the second number.
8.
Press the numerical key 3 and count the blinks for the third number.
9.
Press the numerical key 4 and count the blinks for the fourth number.
10. Write the code, with a permanent pen, in the boxes in the battery cover and this manual.
11. Now the RCU is programmed to control your TV.
5.
SPECIAL SETUP FUNCTIONS
It is possible to control a second TV or VCR with your RCU. One of the other mode keys (TV,
VCR) must be sacrificed in this case. It is not possible to sacrifice the SAT key.
5.1. SETUP A SECOND TV OR VCR
NOTE
The procedure to assign a second TV or VCR is identical, therefor only the
procedure to assign the second TV is given.
1.
On the RCU, press the TV key continuously until the indicator stays on.
2.
Release the TV key and make sure the indicator blinks continuously.
3.
Use the numerical keys to enter code 9 9 2.
4.
Note that the indicator goes on and off and finally stays on.
5.
Press the VCR key once and note that the indicator goes on and off and finally stays off.
6.
Now the VCR key is assigned as a TV key.
7.
Setup the VCR key to control your second TV, refer to chapter 4 for detailed instructions.
5.2. UNDO THE SETUP OF A SECOND TV OR VCR
NOTE
The procedure to undo an assignment for the TV or VCR is identical, therefor only
the procedure to undo the assignment of the VCR key as a second TV is given.
1.
On the RCU, press the VCR key continuously until the indicator stays on.
2.
Release the VCR key and make sure the indicator blinks continuously.
3.
Use the numerical keys to enter code 9 9 2.
4.
Monitor the VCR key and note that the indicator goes on and off and finally stays on.
5.
Press the VCR key once and note that the indicator goes on and off and finally stays off.
6.
Now the VCR key is assigned as a VCR key.
7.
Setup the VCR key to control your VCR, refer to chapter 4 for detailed instructions.
Digital Satellite Receiver
Appendix 2
A2
Page A2 - 5
Hide quick links:
Advertisement
Table of Contents
