The Batteries; The Keys - EchoStar AD-3600 IP Viaccess User Manual

EchoStar Tri Control, Programmable Remote Control Unit
APPENDIX 2
1. INTRODUCTION
This appendix gives the information necessary for the use of the Tri Control with other
equipment than the EchoStar receiver. This appendix also contains a code reference list
which gives the program code for most of the know TV, video and audio equipment.
The Tri Control is and infra red (IR) type programmable remote control unit (RCU) that is able
to control most functions (basic) of your TV and VCR equipment connected to the receiver.
You can program the RCU with a code to which your equipment responds. If the code is not
available in the supplied code list, the built-in intelligence assists you to find the applicable
code.
For future use it is recommended that you make a note of the equipment codes and the serial
number in the fields below: The RCU is already pre-programmed for the EchoStar receiver
with code 0222.
TV key: _ _ _ _
VCR key: _ _ _ _
SAT key: _ _ _ _
Serial Number: _ _ - _ _ _ - _ _
2.

THE BATTERIES

The RCU is powered by two 1.5 Volt Alkaline batteries type AA/LR6. We recommend that you
do not use rechargeable batteries. At battery change, the RCU keeps the programmed
information for a maximum of 15 minutes.
1. Remove the battery cover.
2. Find the battery + and - marks.
3. Insert the batteries accordingly the + and - marks.
4. Install the battery cover.
5. Press the SAT key once, Make sure the key lights up to indicate that it is ready for use.
3.

THE KEYS

If the RCU is programmed with the correct equipment code, the keys should control the same
(basic) functions as the keys on the original remote control unit of that equipment.
The functionality of the SAT mode is discussed in the user's guide of the satellite receiver.
Digital Satellite Receiver
The Power key
This key controls the ON-OFF-STANDBY function.
Indicator
The red indicator shows that the RCU responds to your commands.
Mode keys (TV, VCR, SAT)
These keys are programmable to take control over the television (TV),
video cassette recorder (VCR) and the satellite receiver (SAT).
Numerical keys
The Numerical keys (0-9) activates the same functions as available on
your original remote control unit, such as direct access program
selection.
TV/RAD key
If the function is available, this key operates as the AV key for TV and as
TV/VCR for VCR.
Appendix 2
A2
Page A2 - 1