Connect A Dish - EchoStar AD-3600 IP Viaccess User Manual

Installation
Section 3
.
2.

CONNECT A DISH

It is possible to connect the different dish configurations with the use of RF coaxial cables.
Only the most common configurations are discussed. If in doubt, please ask the EchoStar
service department for advice.
WARNING
ALL EQUIPMENT INVOLVED IN THE INSTALLATION TASK MUST BE INSTALLED CORRECTLY
AND SWITCHED OFF
. U
TASK
TO EQUIPMENT
CAUTION
Tighten the cable connectors only by hand. Do not use any tools. You will damage
the connector pins if you overtighten the connector. This will result in loss of signal
quality, or even total loss of reception.
1. On the dish installation, connect a RF cable (for detailed instructions, refer to the
manufacturer's instructions).
2. On the rear panel of the receiver find the LNB IN (digital), the IF OUT and the
LNB IN ANALOG connectors.
F
IXED DISH INSTALLATION WITH
3. Install the F-connector (dish) to the LNB IN connector (receiver).
4. Install the delivered loop through cable between the IF OUT connector (receiver) to the
LNB IN ANALOG connector (receiver).
Page 3 - 2
. M
AKE SURE THAT IT IS SAFE TO PROCEED WITH THE INSTALLATION
NSAFE CIRCUITS AND INSTALLATIONS CAN CAUSE
.
LNB(F)
( )
SERIOUS INJURY OR DAMAGE
EchoStar AD-3600IP Viaccess