Table of Contents
Advertisement
EchoStar Tri Control, Programmable Remote Control Unit
Appendix 2
4.1. SETUP WITH USE OF THE EQUIPMENT CODE LIST
NOTE
The procedures to set the RCU for the TV and VCR equipment is identical,
therefor only the procedure to setup the TV is given.
1.
Find your brand in the equipment code list.
2.
Switch your TV to on and make sure a broadcast is seen.
3.
On the RCU, press the TV key continuously until the indicator stays on.
4.
Release the TV key and make sure the indicator blinks continuously.
5.
Use the numerical keys to enter the first code that is listed behind your brand name.
6.
Note that the indicator blinks three times.
7.
Aim the RCU at your TV and press the on/standby key and make sure the TV switches
off.
8.
Now the RCU is programmed to control your TV.
9.
If there is no response aim and press again. If there is no response, the first code is not
valid for your TV. Repeat the previous steps with the next code given.
10. If the TV does not respond at the last code, continue with the next procedure
4.2. SETUP WITH USE OF THE SEARCH CODE FEATURE
NOTE
A completed search is indicated by eight blinks.
If the original remote control unit for the VCR does not have a on/off key: before
you continue insert a tape before you continue;
For some codes the play or Volume + key might work.
1.
Switch your TV to on and make sure a broadcast is seen.
2.
On the RCU, press the TV key continuously until the indicator stays on.
3.
Release the TV key and make sure the indicator blinks continuously.
4.
On the RCU, press the on/standby key and see that the indicator of the TV key stays on.
5.
Press the up key once and see if the TV switches off.
Make sure you wait at least 2 seconds to allow the TV to respond.
6.
If the TV does not switch off, repeat step 5 until the TV switches off.
7.
After the TV switched off, press the OK key to store the code.
8.
On the RCU, press the key that you normally would use to switch on the TV. See that the
TV key blinks once and the TV switches on.
9.
Now your are ready to read-out the code from the memory for future use.
Page A2 - 4
EchoStar AD-3600IP Viaccess
Hide quick links:
Advertisement
Table of Contents
