ECM Puristika 81025 User Manual page 23

Now you can begin to operate your machine:
1. Attach connecting hoses to the top back of the machine.
2. Put the other end of the connecting hoses throug the corresponding holes of the water tank lid.
Important!
Make sure to attach the silicone hoses according to the marking on the lid of the water tank
and the back of the machine!
If the connecting hoses are attached incorrectly, the machine will not draw water.
3. Attach the silicone hose on the inside of the water tank lid.
4. Fill the water tank with fresh water, preferably deficient in lime.
5. Place the lid with the silicone hoses on the water tank.
6. Insert the plug properly into the socket and turn the on/off switch on the back of the machine down to "-
". Now the machine is switched on.
Important!
For the initial set-up the boiler has to be filled.
7. A pump noise should be heard. The boiler is now being filled with water. When using the machine for
the first time, it can take a few seconds. Before preparing the first coffee, please rinse the machine by
extracting about 2-3 water tank fillings. Let the water run out of the brew group.
Now let the water run out of the brew group by moving the brew group lever horizontally upwards. Then
put it back down again.
The machine will now heat up. The PID display shows the boiler temperature. The pump pressure gauge
may deflect during the heating phase. Please note that this deflection is not relevant to the process and
can be disregarded.
Clamp the empty portafilter into the brewing group in order to preheat filter and portafilter. You can
accelerate this process by dispensing water from the brew group.
As a large amount of water is required for the first filling of the boiler, the water tank has to be refilled
with fresh water.
The machine is ready for operation when the temperature set on the PID display (approx. 93°C) has been
reached.
Important!
The PID-control assists the machine in keeping a constant boiler temperature. This means that
•
the machine constantly regulates the temperature and the small dot in the PID display flashes
for one heating interval at a time. The boiler temperature is indicated on the PID-display.
Make sure that there is always enough water in the glass water tank during operation.
•
If there is no water in the tank, the machine draws air and a loud pumping noise can be heard. If
the pump does not draw water after filling, switch off the machine and let it cool down before
switching it on again.
Translation of the German original user manual
#1 and #2: Connecting hoses
#3: Silicone hose
#1
#2
ENGLISH
#3
22