Table of Contents
Advertisement
5.0 Installation and Use
5. Lift both arms away from lock offs (Fig. 27a).
6. Route LATCH belt through the rear facing
safety belt path (Fig. 27b) leaving the
adjuster side of the LATCH belt on the
child's LEFT side (Fig. 27c).
NOTE: Remove any twist in webbing to
ensure the webbing lies flat for securing
the restraint to the vehicle.
7. Attach the LATCH connector to the
vehicle's LATCH anchor with the release
button facing downwards towards the
seat cushion (Fig. 27d). Ensure that the
adjuster side of the LATCH belt is on the left
side of the car seat.
NOTE: If the adjuster is facing the wrong
direction or LATCH connector is upsidedown,
the restraint will not secure to the vehicle
properly.
8. Put weight in the seat with your hand to
compress the vehicle seat cushion then attach
the LATCH connector to the vehicle's LATCH
anchor and pull adjuster belt tight as possible
(Fig. 27e). Pull up on LATCH connector as to
ensure the LATCH is secure.
27
Fig. 27a
Fig. 27b
Fig. 27c
Fig. 27d
Fig. 27e
Copyright © 2018, Baby Trend, Inc.
5.0 Installation and Use
9. Press both arms into place and hold
(Fig. 28a).
10. Rotate both rear facing lock offs to the
locked position. Ensure the rear facing lock
offs snap into position (Fig. 28b).
11. Lower flap and secure hook and loop
fasteners and all snaps (Fig. 28c).
12. Ensure the rear facing angle indicator
bubble is located between the boundary
lines (Fig. 28d).
13. Check for movement of the restraint at the
safety belt path. The restraint should not
move more than 1 inch in any direction. If
the restraint moves more than 1 inch, repeat
all steps until all safety steps are met.
5.5 Forward Facing Installation with Vehicle Lap/shoulder Belt
and Top Tether
Requirements. See section 2.3:
Weight is 23 - 65 lbs (10.43 - 29 kg)
Height is 50 inches (127 cm) or less.
Age is 1 year old.
Copyright © 2018, Baby Trend, Inc.
Fig. 28a
Fig. 28b
Fig. 28c
Fig. 28d
Top Tether
28
Advertisement
Table of Contents
