Table of Contents
Advertisement
5.0 Installation and Use
4. Rotate both Rear Facing Lock Off toward the
center of the restraint (Fig. 19a).
5. Lift both arms away from lock offs (Fig. 19b).
6. Route vehicle lap/shoulder belt through the
rear facing safety belt path (Fig. 19c).
NOTE: Remove any twist in webbing to
ensure the webbing lies flat for securing the
restraint to the vehicle.
7. Put weight in seat with hand to compress
the vehicle seat cushion then insert the seat
buckle tongue into the buckle and pull the
vehicle lap/shoulder belt tight as possible
(Fig. 19d). Pull up on buckle as to ensure the
buckle is secure.
8. Press both arms into place and hold
(Fig. 19e).
19
Fig. 19a
Fig. 19b
Fig. 19c
Fig. 19d
Fig. 19e
Copyright © 2018, Baby Trend, Inc.
5.0 Installation and Use
9. Rotate both Rear Facing Lock Off to the
locked position. Ensure the Rear Facing Lock
Off snap into position (Fig. 20a).
10. Lower flap and secure hook and loop
fasteners and all snaps (Fig. 20b).
11. Ensure the rear facing angle indicator
bubble is located between the boundary
lines (Fig. 20c).
12. Check for movement of the restraint at the
safety belt path. The restraint should not
move more than 1 inch in any direction. If
the restraint moves more than 1 inch, repeat
all steps until all safety steps are met.
NOTE: If needed a rolled up towel or pool
noodle can be used for extra elevation
and angle adjustment.
5.3 Rear Facing Installation with Lap Belt.
Requirements. See section 2.1:
Weight is 5 - 22 lbs (2.3 - 10 kg)
The top of head has
NOT
reached max
height red line on seat back. Refer to
warning label on top of seat for reference.
Copyright © 2018, Baby Trend, Inc.
Fig. 20a
Fig. 20b
Fig. 20c
Without headrest
20
Advertisement
Table of Contents
