Latch Connector Belt Rerouting - Baby Trend PROtect Series Owner's Manual

5.0 Installation and Use
6. Put weight in the seat with your hand to 6. Put weight in the seat with your hand to
compress the vehicle seat cushion then compress the vehicle seat cushion then
attach the LATCH connector to the vehicle's attach the LATCH connector to the vehicle's
LATCH anchor and pull adjuster belt tight LATCH anchor and pull adjuster belt tight
as possible (Fig. 35b). Pull up on LATCH as possible (Fig. 35b). Pull up on LATCH
connector as to ensure the LATCH is secure. connector as to ensure the LATCH is secure.
7. Raise Forward Lock-off over the LATCH belt. 7. Raise Forward Lock-off over the LATCH belt.
Engage the lock tab and press down to lock Engage the lock tab and press down to lock
(Fig. 35c). (Fig. 35c).
8. Lower flap and secure hook and loop 8. Lower flap and secure hook and loop
fasteners (Fig. 35d). fasteners (Fig. 35d).
9. Attach Top Tether to a designated anchor 9. Attach Top Tether to a designated anchor
point. Pull Top Tether strap until webbing point. Pull Top Tether strap until webbing
strap is snug (Fig. 35e). strap is snug (Fig. 35e).
NOTE: Your automobile's owner's manual NOTE: Your automobile's owner's manual
will give the anchor locations and maximum will give the anchor locations and maximum
weight of the restraint's occupant for LATCH weight of the restraint's occupant for LATCH
connections. connections.
10. Check for movement of the restraint at the 10. Check for movement of the restraint at the
safety belt path. The restraint should not safety belt path. The restraint should not
move more than 1 inch in any direction. If move more than 1 inch in any direction. If
the restraint moves more than 1 inch repeat the restraint moves more than 1 inch repeat
all steps until all safety steps are met. all steps until all safety steps are met.
35
Fig. 35a
Fig. 35b
Fig. 35c
Fig. 32d
Fig. 32e
Copyright © 2018, Baby Trend, Inc.
5.0 Installation and Use

5.8 LATCH Connector Belt Rerouting

Reroute From Forward Facing Belt Path to Rear Facing Belt Path:
The correct belt path must be used for proper installation.
1. Lift back flap and place harness to side.
2. Unlock and lower Forward Facing Lock-off.
3. Unthread LATCH belt out of the front facing
safety belt path.
4. Engage the Forward Lock-off tab and press
down to lock.
Copyright © 2018, Baby Trend, Inc.
36