Baby Trend PROtect Series Owner's Manual page 14

5.0 Installation and Use
WARNING
Never use a Top Tether connector in a rear facing
installation!!
The Convertible car seat, in a Rear Facing installation, was designed
with a removable upper seatback to allow for a proper installation
when the upper seatback comes in contact with the front seat. If the
upper seatback comes in contact with the front seat and prevents
a 45 degree installation, remove the upper seatback and install
the Convertible at 45 degrees per the instructions in this section.
To remove the upper seatback refer to section 5.15 and read all
WARNINGS.
Reinstall the upper seat back when child reaches 22 lbs. (9.98 kg.),
or the top of the child's head has NOT reached max height red
line on seat back. Keep child rear facing as long as possible. If
you have any questions regarding the use of the upper seat back
or any other questions please contact Baby Trend Customer Service
at 1-800-328-7363.
Rear Facing Installation with LATCH Lower Anchor. With Headrest.
Requirements. See section 2.2:
Weight is between 5 and 40 lbs (2.3 kg and 18.1 kg),
and head is 1 inch below the top of the seat.
25
With headrest
Copyright © 2018, Baby Trend, Inc.
5.0 Installation and Use
1. Squeeze recline handle and recline the seat to
positions 1, 2, or 3. Angling the seat will keep
the baby's head back and airway open.
NOTE: If needed a rolled up towel or pool
noodle can be used for extra elevation and
angle adjustment.
2. Place this restraint in a rear seating position and ensure vehicle is level.
3. Unsnap the 2 front snaps and the 2 side
snaps. Lift and fold back padding.
4. Rotate both Rear Facing Lock Off toward the
center of the restraint.
Copyright © 2018, Baby Trend, Inc.
Rear of Vehicle
26