Table of Contents
Advertisement
PQQX14670ZA.book 54 ページ ２００５年２月２２日 火曜日 午後１２時０分
If the Following Appear on Your Display...
The following will be displayed when the unit needs your attention.
Display message
Recharge battery
Charge for 6h
No link to base.
Move closer to
base, try again.
Please lift up
and try again.
Busy
Error!!
Phone book full
System is busy.
Please try again
later.
Save error
Dial locked
Line in use
Line on hold
54
Cause & Remedy
• The battery needs to be charged. Recharge the
battery (p. 9).
• The battery has been discharged. The handset will
not work. Fully charge the battery (p. 9).
• The handset has lost communication with the base
unit. Walk closer to the base unit and try again or
re-register the handset (p. 49).
• Confirm the base unit's AC adaptor is plugged in.
• Raise the base unit antenna.
• A handset button was pressed while the handset
was on the base unit. Lift the handset and press the
button again.
• The base unit is in use. Try again later.
• When you tried to re-register the handset, the
handset and base unit could not link for some
reason, such as interference from electrical
appliances. Move the handset and base unit away
from any electrical appliances and try again.
• When you tried to store an item in the phone book,
the phone book memory was full. Press [OFF] to exit
the programming mode. To erase other items from
the phone book, see page 37.
• The handset has lost communication with the base
unit. Walk closer to the base unit and try again.
• The entered password was wrong in programming
the Dial Lock. Enter the correct password.
• The Dial Lock is turned on. If necessary, cancel the
Dial Lock (p. 48).
• The base unit is conducting an outside call or a
parallel connected telephone is in use.
• The base unit is on hold for an outside call.
Advertisement
Table of Contents
