Table of Contents
Advertisement
Features
With hardware monitoring - regardless of the operating system and processor - the advantages
compared to conventional software monitoring are clear:
−
suitable for all operating systems and processor types
−
no additional load on processor (performance)
−
optimum reliability, even if process faults or faults are present in the operating system
−
optimum noise reduction
Three different operating modes are available and can be configured in BIOS Setup - System
Management.
Hard disk connection
An ultra ATA/66 hard disk must be connected with a cable especially designed for the ATA/66
mode.
Connect the blue marked end of the cable to the system board.
LAN port
This system board is equipped with the Intel 82559 LAN controller as an option. This LAN controller
supports the transfer speeds 10 Mbit/s and 100 Mbit/s. The LAN controller is equipped with a 3
Kbyte transmission and receiving buffer (FIFO) and supports the WOL function through Magic
Packet.
It is also possible to boot a device without its own boot hard disk via LAN. Here Bootix LAN BootP
and Intel PXE are supported.
The LAN RJ45 connector is equipped with a yellow and a green LED (light emitting diode).
1
Green
a connection exists (e. g. to a hub).
Yellow
Link Mode:
WOL mode:
PCI bus interrupts
The following table shows which PCI bus interrupts on the system board are assigned.
PCI bus interrupt Component on system
A
A
A
B
B
8 - English
2
the LAN connection is active.
a Magic Packet
board:
PCI bus slot 5
PCI bus slot 1
AGP slot
PCI bus slot 2
SMBus
1 = Yellow indicator
2 = Green indicator
TM
is being received.
PCI bus interrupt Component on system
B
C
D
D
D
board:
AC'97 Audio
PCI bus slot 3
PCI bus slot 4
USB controller
LAN controller
U41126-J-Z156-1-74
Advertisement
Table of Contents
