True Fitness TE900 Owner's Manual page 30

CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
Step 15 Power Cord Retainer:
a) Install the power cord retainer assembly in
the order shown, but do no tighten.
b) Rotate power cord retainer down and
tighten the screw to push the retainer up
against the power cord.
Hardware Required:
1 spacer
Note: The 110V spacer is 1-3/4" long.
1 retainer-power cord
1 bolt M5 x 60
Step 16 Power Cord Installation:
CIRCUIT BREAKER: In the event the
current drawn by the treadmill exceeds a
specified threshold value, the Circuit
Breaker will operate; the button will pop
out, and open the circuit. If this should
occur, please wait 10 minutes and then
reset the Circuit Breaker by pressing the
button in on Circuit Breaker. If it does not
reset, or the Circuit Breaker operates
again, please contact True Fitness Service
department at 1-800-883-8783.
Truefitness.com / 800.426.6570 / 636.272.7100
110V
configuration
CLOSED
CIRCUIT BREAKER POSITIONS
OPEN
26