Trunk Commands Set - Planet ISW-1022M User Manual

6.3 Trunk Commands Set

Netstar Commands
aggregator priority
[1~65535]
aggregator activityport
[Group ID]
[Port Numbers]
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
aggregator group
[GroupID] [Port-list]
nolacp
show aggregator
no aggregator lacp
[GroupID]
no aggregator group
[GroupID]
Level Description
G Set port group system priority switch(config)#aggregator priority 22
G Set activity port
G Assign a trunk group with
LACP active.
[GroupID] :1~3
[Port-list]:Member port list,
This parameter could be a port
range(ex.1-4) or a port list
separate by a comma(ex.2, 3,
6)
[Workport]: The amount of
work ports, this value could
not be less than zero or be
large than the amount of
member ports.
G Assign a static trunk group.
[GroupID] :1~3
[Port-list]:Member port list,
This parameter could be a port
range(ex.1-4) or a port list
separate by a comma(ex.2, 3,
6)
P Show the information of trunk
group
G Disable the LACP function of
trunk group
G Remove a trunk group
123
User's Manual of ISW-1022M
Example
switch(config)#aggregator activityport 2
switch(config)#aggregator group 1 1-4 lacp
workp 2
or
switch(config)#aggregator group 2 1,4,3 lacp
workp 3
switch(config)#aggregator group 1 2-4
nolacp
or
switch(config)#aggregator group 1 3,1,2
nolacp
switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
switch(config)#no aggreator lacp 1
switch(config)#no aggreator group 2