3Ware 9550SX-4LP User Manual page 246

Chapter 11. Troubleshooting
03Ch Initialize paused
This AEN will be sent when the initialization is paused.
Initializations are normally paused for ten minutes after a system first boots
up and during non-scheduled times when scheduling is enabled. Initializations
follow the rebuild schedule.
03Dh Verify paused
This AEN will be sent when the verify operation is paused.
Verifies are normally paused for ten minutes after a system first boots up and
during non-scheduled times when scheduling is enabled.
03Eh Migration paused
This AEN is sent when migration is paused. Migration follows the rebuild
schedule. For more information, see "Scheduling Background Tasks" on
page 184.
03Fh Flash file system error detected
The 3ware RAID controller stores some configuration parameters as files in
its flash memory. This AEN will be sent when a corrupted flash file system is
found on the controller during boot-up. A further attempt will be made to
repair the flash file system. These files usually get corrupted when a flash
operation is interrupted by events such as power failures.
040h Flash file system repaired
This AEN will be sent if a corrupted flash file system is successfully repaired.
Some of the flash files with insufficient data may be lost in the operation. The
configuration parameters which are lost will then return to their default
values.
041h Unit number assignments lost
The 3ware RAID controller tries to keep the unit numbers persistent across
soft resets. This AEN will be sent if unit number assignments were lost from
some unknown reasons.(This event rarely happens. Please contact AMCC
3ware technical support if this event occurs.)
042h Primary DCB read error occurred
This AEN will be sent when the controller finds error in reading the primary
copy of the Disk Configuration Block (DCB). The back-up copy of the DCB
236 3ware Serial ATA RAID Controller User Guide