3Ware 9550SX-4LP User Manual page 101

To see additional detail about a particular drive, including the SMART data,
whether NCQ is supported and enabled, and the SATA Link speed, click the
link in the Port # column.
Port #.
Model.
Capacity.
on 3DM screen is calculated as 1KB = 1024. This amount may differ from the
capacity that is printed on the disk drive, where it typically has been
calculated as 1K = 1000. Consequently, the capacity of the drive may appear
smaller in the 3DM screens. No storage capacity is actually lost; the size has
simply been calculated differently for consistency.
Serial #.
Firmware.
The unit the drive belongs to, if applicable.
Unit.
Status.
Failure, Orphan, DCB Data Check, Unsupp DCB, Unconv DCB, Offline
JBOD, Not Present, Device Error, SMART Failure, ECC Error, or Drive
Removed. (In the event of a problem, the status shown for the drive can be
useful to customer support.)
Blink. Check this box to cause the LED for this drive to blink, if it is in a
chassis that has a Chassis Control Unit (CCU) and is connected to the I
connector on the 9550SX or 9590SE controller.
www.3ware.com
The port to which the drive is connected.
The model of the drive.
The physical capacity of the drive. (Note that the capacity as shown
The serial number of the drive.
The firmware version of the drive.
The status of the drive: OK, Not Supported, Read Timeout, Read
In most cases, the status of the drive will not correspond to
Note:
the status of the unit, shown on the Unit Information page.
3DM 2 Reference
2
C
91