Changing The Needle - Singer Stylist 7258 Instruction Manual

更换机针

CHANGING THE NEEDLE

1. 逆时针转动手轮，提升针杆到最高位置。
2. 放松针夹螺钉。
3. 取下旧针。
4. 将新的针插入针夹中，针柄平面向后。
5. 沿槽向上推到顶。
6. 用螺钉起子拧紧针夹螺钉。
1. Raise the needle bar to its highest position by turning the hand
wheel toward you.
2. Loosen the needle clamp screw by turning it toward you.
3. Remove the needle by pulling it downward.
4. Insert the new needle into the needle clamp with the flat side
toward the back.
5. Push the needle up as far as it can go.
6. Tighten the needle clamp screw firmly with the screw driver.
注意：适当拧紧螺钉，但不要拧得过紧。
NOTE: Tighten snugly, but do not over tighten.
友情提示：在压脚下放一块碎布或一张纸，这样在换
机针时可避免机针掉入针板槽内。
Helpful Hint: Placing a scrap of fabric under the presser foot
and lowering the presser foot makes it easier to change the
needle and will preclude dropping the needle into the needle
plate slot.
Always disconnect the machine from power supply by
removing the plug from the wall-outlet.
针柄平面
Flat side
限位销
Stop pin
针柄平面向后
Flat side toward the back
机针
Needle
17