Verifying Printer Setup - Lexmark MX517 User Manual

Additional printer setup
For Macintosh users
1
From System Preferences in the Apple menu, navigate to the list of printers, and then select + > IP.
2
Type the IP address in the address field.
3
Apply the changes.
Setting up serial printing (Windows only)
1
Set the parameters in the printer.
a
From the control panel, navigate to the menu for the port settings.
b
Locate the menu for the serial port settings, and then adjust the settings, if necessary.
c
Apply the changes.
2
From your computer, open the printers folder, and then select your printer.
3
Open the printer properties, and then select the COM port from the list.
4
Set the COM port parameters in Device Manager.
Notes:
•
Serial printing reduces printing speed.
•
Make sure that the serial cable is connected to the serial port on your printer.

Verifying printer setup

When all hardware and software options are installed and the printer is turned on, verify that the printer is set
up correctly by printing the following:
•
Menu settings page—Use this page to verify that all printer options are installed correctly. If an option you
installed is not listed, then it is not installed correctly. Remove the option, and then install it again.
•
Network setup page—If your printer has networking support, then use this page to verify that the network
connection is working. This page also provides important information that aids network printing
configuration.
Printing a menu settings page
From the home screen, navigate to:
> Reports > Menu Settings Page
51