Hummer 2009 H3 Owner's Manual page 317

the center of the wheel. Tilt the
tire/wheel retainer (B) down
through the center wheel opening.
3. Make sure the tire/wheel
retainer (B) is fully seated across
the underside of the wheel.
4. Assembly the two jack handle
extensions (F) and wheel
wrench (G).
5. Insert the hoist end of the
extension tool (I) through
the hoist shaft access ramp (H).
6. Raise the tire part upward.
Make sure the tire/wheel
retainer (B) is seated in the
wheel opening.
Service and Appearance Care
7. Raise the tire fully against the
underside of the vehicle by
turning the wheel wrench
clockwise until you hear
two clicks or feel it skip twice.
You cannot overtighten the cable.
8. Push, pull (A) and then try to
turn (B) the tire. If the tire
moves, use the wheel wrench
to tighten the cable.
5-81