License Plate Lamp; Replacement Bulbs - Hummer 2009 H3 Owner's Manual

To replace one of these bulbs in the
taillamp assembly:
1. Open the tailgate. See Tailgate
on page 2-7.
2. Remove the two screws from the
taillamp assembly.
3. Pull the taillamp assembly away
from the vehicle.
4. Turn the bulb socket
counterclockwise to remove it
from the taillamp assembly.
5. Pull the old bulb to release it
from the socket.
6. Turn the bulb socket clockwise to
reinstall in the taillamp assembly.
7. Reinstall the taillamp assembly
making sure to line up the pins
with the vehicle.
8. Reinstall the two screws.

License Plate Lamp

To replace one of these bulbs:
1. Remove the two screws holding
the license plate lamp.
2. Pull the license plate lamp away
from the fascia.
3. Turn the bulb socket
counterclockwise and pull the
bulb straight out of the license
plate lamp assembly.
Service and Appearance Care
4. Install the new bulb into the
socket.
5. Reverse Steps 1 through 4 to
reinstall.

Replacement Bulbs

Exterior Lamp
Back-up Lamp (H3T)
Back-up (H3),
Stoplamp,
Taillamp and Turn
Signal Lamp
License Plate Lamp
Low-Beam and
High-Beam
Headlamp
For replacement bulbs not listed
here, contact your dealer/retailer.
5-43
Bulb
Number
W16W
3157K
194
H13