Advertisement
Two-Piece Front Turn Signal Lamp Assembly
4..
Remove the headlamp assembly as shown under
"Two-Piece Composite Headlamp System" earlier in
this section.
2. Locate the locking tabs
on the assembly.
Squeeze the tabs
together and push that
end of the assembly out
while holding the tabs.
The assembly will
swing out.
4. Turn the harness bulb socket to the left to remove
it.
3. Unplug the electrical connector.
5. Push the new bulb into the socket until it snaps
into place.
and turn it to the right until it is tight.
the lamp assembly back into the vehicle. Then swing
the assembly in and snap it into place.
6 . Put the new bulb into the headlamp lens assembly
7. To replace the assembly, snap the outboard end of
6-38
Advertisement
