Table of Contents
Advertisement
Two-Piece Front Thrn Signal Lamp Assembly
1. Remove the headlamp assembly as shown under
"Two-Piece Composite Headlamp System'' earlier in
this section.
2.
Locate the locking
tabs on the
assembly. Squeeze
the tabs together
and push that end
of the assembly out
while holding the
tabs. The assembly
will swing out.
3. Unplug the electrical connector.
4.
Turn the harness bulb socket to the left to remove it.
5. Push the new bulb into the socket until it snaps
6. Put the new bulb into the headlamp lens assembly
into place.
and turn it to the right until it is
tight.
7. To replace the assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then swing
the assembly in and snap it into place.
6-37
Advertisement
Table of Contents
