Advertisement
9. Stow the seat belt latch plate on the clip at the
window trim.
Replacing the Rear Seat
1. Remove the trim covers from the floor rails.
2. Position the seat into the open slots in both rails.
Push the seat forward in the rail, hooking both seat
bases onto the pins inside of the rails.
3. Both locking pins that lock the seat into place must
be installed before operating the vehicle.
4. To install the locking pin at the rear of the seat base,
pull the carpedmat flap back on the inboard side to
locate the hole in the rail for the pin.
5. Remove the pin from its stowed position on the seat
base while holding the carpet/mat flap back.
1-8
Advertisement
