Setting Time Code Generator - JVC GY-HM890U Instructions Manual

Time Code Operation Mode
Three types of time code operation ("FREE",
"REC", "REGEN") can be selected with the [TC
GENE.] switch.
Setting
FREE The time code operates in the
0
run mode at all times
regardless of the recording
status.
It continues to run even when
0
the power of the camera
recorder is turned off.
Synchronizes with the external
0
time code when an external
time code generator is
connected.
(A P78 [Synchronizing the
Time Code with an External
Time Code Generator] )
REC The time code operates in the run
mode during recording. It
continues to run in the order of the
recorded clips as long as the SD
card is not replaced. If the SD card
is removed and recording is made
on another card, time code will be
recorded on the new card from
where it was left off in the previous
card.
REGEN The time code operates in the run
mode during recording. When the
SD card is replaced, the last time
code recorded on the card is read
and recorded on a new card so that
the time code continues in running
order.
(A P74 [Presetting the Time
Code] )
Memo :
When [Main Menu] B [System] B [Record Set]
0
B [Rec Mode] is set to "Variable Frame",
"Interval Rec" or "Frame Rec", and the [TC
GENE.] switch is set to "FREE", Rec Run mode
is activated.
(A P135 [ Rec Mode ] )
When [Main Menu] B [System] B [Record Set]
0
B [Record Format] B [WFormat]/[YFormat] is
set to "AVCHD", Pre Rec enters Free Run mode.
(A P133 [ W Format ] )
(A P134 [ Y Format ] )
Description
Setting Time Code
Generator
Presetting the Time Code
Time code and user's bit data generated from
0
the internal time code generator are recorded.
This section describes how to set [TC/UB] B [TC
0
Preset].
(A P119 [ TC Preset ] )
Memo :
When the frame rate in [Main Menu] B [System]
0
B [Record Set] B [Record Format] B [WFrame
& Bit Rate]/[YFrame & Bit Rate] is set to "50p",
"50i", "25p" or "24p", setting to "Drop" is
disabled.
(A P133 [ W Frame & Bit Rate ] )
(A P134 [ Y Frame & Bit Rate ] )
You can configure the setting without accessing
0
the [TC/UB] menu screen.
(A P75 [Setting Time Code without Opening
the Menu] )
Required Settings Before Preset
.
1 Set the [TC GENE.] switch to "REC" or
"FREE".
[REC]:
0
Preset data in the time code generator
operates in run mode during recording mode.
Set this when recording continuous time
code in connecting frames.
[FREE]:
0
Time code starts to operate in run mode from
the preset time in the time code generator.
Time Code and User's Bit
73