Ford 1996 Aerostar Manual page 49

Until a floor anchor is installed, follow these
steps to install a tethered child safety seat in the
front seat:
1. Buckle the lap/shoulder belt in the seat
directly behind the front passenger seat.
2. Pull all the stored belt out of the rear seat
belt retractor to switch the retractor to
automatic locking mode.
3. Let the retractor wind up the slack from the
lap/shoulder belt.
4. Install the child safety seat in the right front
seat. Refer to the previous section on
Installing Child Safety Seats. Hook the tether
strap around the webbing near the center of
the shoulder portion of the lap/shoulder
belt.
5. Tighten the tether strap.
Until floor-mounted tether anchors are installed,
tether straps of child safety seats in the second
row may be anchored to lap/shoulder belts for
the third row, following the five steps above, or
to the tongue of the third row lap belt.
Failure to follow these precautions could
increase the chance of injury in an
accident.
If the anchor bolt(s) is ever removed, the
hole(s) in the floor must be sealed to
prevent the possibility of exhaust fumes
entering the passenger compartment.
RWARNING
RWARNING
47