Table of Contents
Advertisement
c
Mount the inner dome that was removed according the steps in page 34 in the reverse proce-
dure. Check to see that the tilting lock screws of the camera are properly engaged in the holes
of the inner dome.
Tighten the screws that have been loosened in step x on page 34 using the bit for tamper-
proof screw (accessory).
Important:
• Securely tighten all the fixing screws (x3) of enclosure. Otherwise, water exposure may cause
damage or malfunction of camera, or camera dropping may result in injury. (Recommended
tightening torque: 0.78 N·m {0.58 lbf·ft})
• Attach the inner dome in accordance with the direction of the lens opening not to change the
lens direction.
• Check if the inner dome and tilting lock screws are firmly fit.
• Remove the protection sheet from the outside of the dome.
40
Groove for
mounting
Cutout for
mounting
Advertisement
Table of Contents
