Table of Contents
Advertisement
t Attach the base cover that was removed
according the steps in page 21.
y Use the bit for tamperproof screw (accessory)
to tighten the fixing screws provided on both
sides of the base cover. (Recommended tight-
ening torque: 0.78 N·m {0.58 lbf·ft})
x
Detach the enclosure and inner dome from the
main body by loosening the three fixing screws.
Loosen the three fixing screws by using the bit
for tamperproof screw (accessory).
Detach the inner dome while pushing toward
the directions as indicated by the arrows in the
illustration.
Important:
• Do not hold the inner dome when carrying the
camera. Otherwise, the camera part may fall
and it may damage the camera.
• Remove the cover film from the transparent part
of the dome cover after the installation is com-
plete. Do not touch the dome cover by hand
directly after removing the cover film.
34
Base cover
Base cover
fixing screw
Push.
Push.
Advertisement
Table of Contents
