Special Cleaning Functions; Vapor Clean (On Some Models Only) - Smeg SO6302S3PX Manual

above procedures to put the rack/tray
support frames back in.

Special cleaning functions

• From position 0, turn the function knob to the
left by one position. The

Vapor Clean (on some models only)

See General safety instructions.
The Vapor Clean function is an assisted
cleaning procedure that facilitates the
removal of dirt. Thanks to this process, it
is possible to clean the inside of the
oven very easily. The dirt residues are
softened by the heat and water vapour
for easier removal afterwards.
Preliminary operations
Before starting the Vapor Clean cycle:
• Completely remove all accessories from
inside the oven.
• Remove the temperature probe, if present.
• Remove the self-cleaning panels, if present.
• Pour approx. 120 cc of water onto the floor
of the oven. Make sure it does not overflow
out of the cavity.
• Spray a water and washing up liquid
solution inside the oven using a spray
nozzle. Direct the spray towards the side
walls, upwards, downwards and towards
the deflector.
We recommend spraying approx. 20
times at the most.
Do not spray the deflector if it has a self-
cleaning coating.
• Close the door.
• During the assisted cleaning cycle, wash the
self-cleaning panels (where fitted), which
were previously removed, separately in
warm water and a small amount of
detergent.
914779559/B
Vapor Clean cycle setting
button flashes.
1. After entering the special functions menu,
2. Press the
3. Press the
At the end,
and a buzzer sounds.
4. Turn the function knob to position 0 to exit
Programmed Vapor Clean cycle
It is possible to program the Vapor Clean
function start time, like any cooking function.
If the indoor temperature is higher than
expected, the function is not activated
and every time the
pressed the appliance sounds an
acoustic warning.
Let the appliance cool down before
activating the function.
press the button until the
function is selected.
button to confirm.
button to start the function.
The duration and temperature
parameters cannot be changed by the
user.
is displayed and flashes
the function.
CLEANING AND MAINTENANCE - 89
button is