Special Cleaning Functions; Vapor Clean (On Some Models Only) - Smeg SOP6302TX Manual

• The rack/tray support frames.
In the event you are using specific
cleaning products, we recommend
running the oven at maximum
temperature for 15-20 minutes in order
to eliminate any residue.
Drying
Cooking food generates moisture inside the
appliance. This is a normal phenomenon and
does not affect the appliance's operation in any
way.
Each time you finish cooking:
1. Let the appliance cool down.
2. Remove any dirt from inside the appliance.
3. Dry the interior of the appliance with a soft
cloth.
4. Leave the door open until the inside of the
appliance has dried completely.
Cleaning the probe
After use, the temperature probe should be
cleaned after it has cooled down. Clean the tip
of the temperature probe (metal part) with
water, neutral dish soap and a soft sponge.
Clean the rest with a soft damp cloth.
Do not wash it in a dishwasher as it could
damage the electrical components of the plug.
Dry thoroughly after cleaning.
Removing racks/trays support frames
Removing the rack/tray support frames enables
the sides to be cleaned more easily.
To remove the rack/tray support frames:
• Pull the frame towards the inside of the oven
cavity to unhook it from its groove A, then
slide it out of the seats B at the back.
• When cleaning is complete, repeat the
above procedures to put the rack/tray
support frames back in.

Special cleaning functions

• From position 0, turn the function knob to the
left by one position. The
72 - CLEANING AND MAINTENANCE

Vapor Clean (on some models only)

Preliminary operations
Before starting the Vapor Clean cycle:
• Completely remove all accessories from
• Remove the temperature probe, if present.
• Remove the self-cleaning panels, if present.
• Pour approx. 120 cc of water onto the floor
• Spray a water and washing up liquid
• Close the door.
• During the assisted cleaning cycle, wash the
Vapor Clean cycle setting
button flashes.
See General safety instructions.
The Vapor Clean function is an assisted
cleaning procedure that facilitates the
removal of dirt. Thanks to this process, it
is possible to clean the inside of the
oven very easily. The dirt residues are
softened by the heat and water vapour
for easier removal afterwards.
inside the oven.
of the oven. Make sure it does not overflow
out of the cavity.
solution inside the oven using a spray
nozzle. Direct the spray towards the side
walls, upwards, downwards and towards
the deflector.
We recommend spraying approx. 20
times at the most.
Do not spray the deflector if it has a self-
cleaning coating.
self-cleaning panels (where fitted), which
were previously removed, separately in
warm water and a small amount of
detergent.
If the indoor temperature is higher than
expected, the function is not activated
and every time the
pressed the appliance sounds an
acoustic warning.
Let the appliance cool down before
activating the function.
button is
914779561/D