Table of Contents
Advertisement
the drain pipe on the right side of the rear wall
of the oven cavity.
4. Wait for the end of the drain flow.
At the end an acoustic signal sounds and the
display shows
5. Drain the water from the deep pan.
It is recommended to carry out the
cleaning process of the reservoir and
the water circuit a couple of times.
You can also use a cleaning solution
instead of water. In this case it is
advisable to carry out at least a couple
of water rinses afterwards, following the
instructions in this chapter.
Extraordinary maintenance
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
Replacing the internal light bulb
Power voltage
Danger of electrocution
• Unplug the appliance.
• Wear protective gloves.
1. Completely remove all accessories from
inside the oven.
2. Remove the rack/tray support frames.
3. Use a tool (e.g. a spoon) to remove the bulb
cover.
INSTALLATION
Electrical connection
See General safety instructions.
914779559/B
.
Take care not to scratch the enamel of
the oven cavity wall.
4. Slide out and remove the light bulb.
Do not touch the halogen light bulb
directly with your fingers, use an
insulating material.
5. Replace the light bulb with one of the same
type (40 W).
6. Refit the cover. Ensure the moulded part of
the glass (A) is facing the door.
7. Press the cover completely down so that it
attaches perfectly to the bulb support.
General information
Check the mains characteristics against the data
indicated on the plate.
The identification plate bearing the technical
INSTALLATION - 97
Advertisement
Table of Contents
