Table of Contents
Advertisement
Installation
Condensed water
The machine is supplied as shown in Option 1
(inset). This means that the condensed water
is pumped into the condensed water container,
which must be removed and emptied by hand.
Option 2 allows you to remove the small short
hose from the nipple. Attach the rubber hose
supplied to the same nipple. The water can then
be pumped out into a sink or a fl oor drain (2a).
NOTE!
• Do not pull on the drain hose and do not
stretch it or allow it to become kinked as it
could get damaged.
• Secure the hose carefully (e.g. by trying it to
a tap to make sure it cannot slip during use).
Otherwise there is a risk of overfl owing water
which could cause damage.
WARNING!
If the tumble dryer is to be connected to a
drainage system already in use by another
appliance it is essential to fi t a non-return valve.
The non-return valve will prevent the risk of
back-fl ow into the dryer which could cause
damage.
25
Advertisement
Table of Contents
