Troubleshooting; The Machine Will Not Start; The Machine Loses All Power During A Programme; The Machine Leaks Water - Asko PROFESSIONAL TDC112HPS Operating Instructions Manual

Troubleshooting

The machine will not start

Check
• that the door is properly closed.
• that the main power switch is on.
• that the plug is connected.
• that the main fuses have not blown.
The machine loses all power during a
programme
Contact the service division.

The machine leaks water

Check that the autofi lter and its seal are
installed correctly and not faulty.

Drying takes too long

• Check that the lint fi lter is not blocked. See
the Care and cleaning chapter.
• Empty the condensed water container.
Clean the evaporator fi lter (net fi lter + foam
fi lter), evaporator, lint fi lter and autofi lter, see
chapter Care and cleaning.

Error messages

• If Over Flow appears on the display, the
condensed water container is full or the
evaporator fi lter is blocked. Empty the
container, clean the fi lter and restart the
machine. See the Care and cleaning chapter.
• Read Drying takes too long in this chapter if
Max program time appears on the display.
• If Clean Lint Filter appears on the display,
clean the lint fi lter.
• If Clean condenser appears on the display,
clean the evaporator. See the Care and
cleaning chapter.
• If Clean auto fi lter appears on the display,
clean the auto fi lter. See the Care and
cleaning chapter.
• Call the service division if Thermistor fault
appears on the display.
• Press the Stop button to close any error
messages.
19