Follow These Instructions - Asko PROFESSIONAL TDC112HPS Operating Instructions Manual

Door hanging
You can choose whether the door is hung on the
right or the left.

Follow these instructions

1. Remove the plinth.
2. Remove the hinge, two screws.
3. Lift the door up and remove it. Support the
door at the same time.
4. Remove both door pins (top and bottom). Fit
them on the other side of the machine. Refi t
the hinge.
5. Also change the hole plug (A) (on top) and
the door hinge bushing (B) (at the top and on
the bottom), and replace them on the other
side of the door.
(A)
Use a fl at-bladed screwdriver to remove the
plugs.
28
pin
(B)
NOTE!
Be careful not to damage the appliance with the
screwdriver.
6. Loosen the screws (13 in total) on the inside
of the door.
7. Loosen the inner part of the door (pull down
and lift out).
8. Switch the catch (magnetic lock) and the
cover plate. First loosen the screw holding
the catch (magnetic lock) in place. Then use
a fl at-bladed screwdriver to remove the cover
plate. Refi t the catch (magnetic lock) and the
cover plate on the other side.
9. Reattach the inner part of the door with the
screws (13 in total).
10.Loosen the two screws holding the handle
in place on the door. Push out the two
plastic plugs inside the screw holes on the
other side of the door. Use the two screws
to attach the handle to the other side of the
door and press the plastic plugs into the
holes where the handle was previously fi tted.
11.Refi t the door by loosening the hinge screws
slightly, affi xing the door and closing it.
Retighten the hinges. Replace the plinth.