Press The Start Button; Drying Programme Fi Nished - Asko PROFESSIONAL TDC112HPS Operating Instructions Manual

Tumble drying

Press the Start button

5
Remaining drying time
An estimate of the remaining drying time
will be shown on the display a few minutes after
the drying programme starts. For example, 1:35
means that it will take approximately 1 hour and
35 minutes for the load to dry.
The actual remaining time may be longer than
the estimated time shown on the display. The
remaining time is then shown as 0:15 until the
load is suffi ciently dry.
You can stop the tumble dryer by pressing the
Stop button or by opening the door. In both
cases the programme is stopped and starts
from the beginning if restarted.
NOTE!
The programme will not be aff ected if you
change the programme selector after the
programme has started.
12
Drying programme fi nished
6
The text Done appears on the display
when the programme is fi nished.
The compressor's cooling fan continues to
run after the programme fi nishes, but stops
automatically or when any button/knob is
activated.
Backlighting
Two minutes after the drying programme
fi nishes the backlighting on the display and
option buttons enters energy saving mode.
Condensed water
The condensed water container must
be emptied after each load. Remove the
condensed water container, empty out the water
and replace the container. If the condensed
water container becomes full to overfl owing,
the programme is interrupted and Over Flow
appears on the display. Empty the container
and press the Start button to start a new
programme.
TIP!
The condensed water is decalcifi ed and can
be used in steam irons. Pour it through a coff ee
fi lter.
Automatic emptying
For connection to a separate drain, see the
installation instructions in the set of documents.
NOTE!
• Clean the lint fi lter after each load.
• Drain the tank after each load.
WARNING!
If the lint fi lter becomes clogged, the machine's
automatic overheating cut-out may be triggered.
Clean the fi lter, wait until the machine has
cooled then try starting it. If it still does not start:
Call the service division.