Trane TRACER SUMMIT Hardware And Software Installation page 71

BMTX-SVN01C-EN
• The CCP IIs software version is shown on the label of the chip at loca-
tion U-27 on the board. The revision level of the board determines
whether previous software versions of the CCP can be upgraded to be
compatible with a Tracer Summit system.
Wiring requirements
To establish wiring connections between the CCP II and the BMTX BCU,
refer to the specifications on wire type, topology, and wire procedures in ""
on page 34. Attach the communication link wiring to the CCP II at TB3-4
and TB3-5
Device addressing
Each CCP II must have a unique address on each link. CCPs can have an
address from 1 through 32. The address is set with the S2 DIP switches
and must match the address that was set in Site Configuration for Tracer
Summit.
For details about setting the address, refer to the CCP II literature.
•
For CCP II DIP switch settings, refer to Table 9.
•
Table 9. CCP II DIP switch settings
UCM address
1
1 on
2 OFF
3 on
4 OFF
5 on
6 OFF
7 on
8 OFF
9 on
10 OFF
11 on
12 OFF
13 on
14 OFF
15 on
16 OFF
17 on
18 OFF
19 on
Description of UCM types
CCP II
S2 DIP switch settings
2 3
OFF OFF OFF
on OFF OFF
on OFF OFF
OFF on OFF
OFF on OFF
on on OFF
on on OFF
OFF OFF
OFF OFF on
on OFF
on OFF on
OFF on
OFF on
on on
on on
OFF OFF OFF
OFF OFF OFF
on OFF OFF
on OFF OFF
4 5
OFF
OFF
OFF
OFF
OFF
OFF
OFF
on OFF
OFF
on OFF
OFF
on OFF
on OFF
on OFF
on OFF
on
on
on
on
59