Advertisement
controler will allow the fan to ramp up to a higher speed. This prevents
cold air from blowing into the passenger compartment.
If you want the blower fan to run only at a fixed high speed, push the
(upper) button until you see "HI" on the display.
If you want the fan speed to be automatic, but you like the fan speed to
be higher than the AUTO setting, just push the buttons until "HI/AUTO"
is shown on the display.
If you want the blower to run only at a fixed low speed, push the (low)
button until "LO" is shown on the display.
I
If you want the fan speed to run lower than the "AUTO" setting, push the
-
button until "AUTO LO" is shown on the display.
DEFROSTER
-
1
Push this button to
remove fog or frost from
the windshield.
This setting sends most of the air flow to the windshield with only a small
amount to the floor outlets. In some cold start conditions, the "AUTO"
blower fan speed may be limited until the cooling system warms up. This
is normal to prevent windshield fogging.
L
I ,
-
The fan speed will work automatically to maintain your requested interior
temperature. If you need more air to your windshield, you should select a
higher fan speed.
-
\
,
It will help a lot if you first clear any ice and snow from the hood and the
-
air inlet (it's between the hood and the windshield).
REAR DEFOGGER
- 1
Push this button to turn
I
I
on the
rear
defogger.
With it, your rear window and both outside rearview mirrors are heated.
The system will automatically shut off after 10 minutes. If further
defrosting is desired, simply push the button again.
154
Advertisement
