[ X Disassembly Procedure ]
6. Fan, fan motor and fan case
1. Remove the control box cover according
to the procedure in section 1.
2. Removing the fan motor
(1) Disconnect the fan motor connector
(CNMF) from the Indoor controller board.
(2) Remove the cable through the rubber
bush.
3. Removing the bottom plate
(1) Remove the thirteen fixing screws on the
bottom plate (R) to remove it.
4. Removing the fan case
(1) Remove the tape from the fan case.
(2) Squeeze the tabs on the fan case (S) to
remove it.
5. Removing the fan and fan motor
(1) Remove the two fixing screws and
attachment on the fan motor (T).
(2) Pull out the fan motor in the direction
of the arrow.
6. Removing the fan case
(1) Remove the eight fixing screws on the
fan case (U) to remove it.
Note: There is no need to re-paste the
tape after replacing the parts.
HWE20020
Fig. 11
(a) Tab
(b) Tape
Fig. 12
Fig. 13
Fig. 14
- 40 -
Exercise caution when removing heavy parts.
(R)
(b)
(U)
(S)
(T)
GB