Thermistor (Condenser/Evaporator) (Liquid Pipe); Drain Pan - Mitsubishi Electric PEA-M200LA Technical & Service Manual

[ X Disassembly Procedure ]

3. Thermistor (Condenser/evaporator) (Liquid pipe)

1. Remove the control box cover according to the
procedure in section 1.
2. Removing the maintenance cover
(1) Remove the nine fixing screws on the cover (D),
cover (E), and cover (F) to remove the maintenance
cover.
3. Removing the thermistor
(1) Disconnect the thermistor connector (CN44) from
the Indoor controller board.
(2) Remove the thermistor (G) from the thermistor
holder (H) on the copper tube.
Thermistor size
Liquid pipe: ø8 mm
Condenser/evaporator: ø6 mm

4. Drain pan

1. Removing the bottom plate
(1) Remove the twelve fixing screws on the bottom
plate (J) to remove it.
2. Removing the drain pan
(1) Pull out the drain pan (K) in the direction of
the arrow.
Note: Drain the water out of the drain pan before removing it.
HWE20020
Exercise caution when removing heavy parts.
(F)
Fig. 3
Indoor controler
board
Fig. 4
Exercise caution when removing heavy parts.
Fig. 5
Fig. 6
- 38 -
(E) (D)
(G), (H)
(J)
(K)
GB