Zenith HydroTap G5 Quick Start Installation Manual page 5

SECTION 2: IMPORTANT SAFETY INSTRUCTIONS
• Do not expose to temperatures exceeding 50˚C.
• Do not expose to naked flame or any incandescent material.
• Do not pierce or burn, even after use. Avoid shock.
• High concentration of gas may cause asphyxiation.
• Use only in an upright position.
• The cylinder must be used with the supplied pressure regulator.
• The gas cylinder must be installed in an open plan area, or in an
enclosed room with a volume no less than 20m³ per 1200g cylinder, or
50m³ per 2640g cylinder.
• If more than 1 gas cylinder containing CO2 is present within the same
location, the recommended ventilated area should be in proportion to
the number of gas cylinders stored in that location. A ventilated area is a
non-enclosed area which could include the kitchen, living room etc.
• Refer to the gas cylinder and MSDS sheet for a complete list of warnings
downloadable from: zenithwater.co.nz.
Qualifications
To avoid hazards, all installation procedures must be carried out by a
suitably qualified tradesperson. The power cable and power outlet must be
in a safe visible position for connection.
Lifting
Take care when lifting. The Command Centre may exceed safe lifting
limits. If you feel this is beyond your personal capabilities, please seek
assistance with the lift. The weight of the Command Centre is marked on
the packaging. Do not lift the Command Centre by the front cover or any of
its connections.
Airflow
The Zenith HydroTap G5 operates within the ambient temperature range
5ºC - 35ºC. Proper air circulation must be provided. The system will operate
satisfactorily only if the recommended air gaps are provided. The vent kit
supplied must be fitted.
Frost protection
If the HydroTap G5 is located where the ambient air temperature could
fall below 5ºC when the system is not in use, do not turn off the Command
Centre electrically.
Quick Start Installation Guide
807120NZ v1.00 01.21 G5 C CS Quick Start Guide
5