Zenith HydroTap G5 Quick Start Installation Manual page 17

SECTION 9: Install the CO2 cylinder and regulator
Fit the regulator and connect the gas hose
• Ensure all mating surfaces are clean.
• Turn the regulator OFF.
• Check the regulator and hose seals, inside the connectors.
• Connect the gas hose to the regulator.
• Carefully screw the regulator onto the cylinder connection.
• For the 1.2kg cylinder and Universal G5 regulator use the adaptor supplied.
• Connect the gas hose to the Command Centre (see section 10).
Do not proceed if the seals are damaged.
!
Take care not to cross thread the regulator. A cross-
threaded regulator poses a potential hazard.
Cylinder valve
2.64kg cylinder
Approved regulators
*The regulator adaptor is only required for the Universal G5 regulator.
Quick Start Installation Guide
807120NZ v1.00 01.21 G5 C CS Quick Start Guide
b
a
CO2 Gas
hose
Regulator
Regulator
adaptor*
1.2kg cylinder
Approved regulators
a
b
CO2 Gas
hose
17