Zenith HydroTap G5 Quick Start Installation Manual page 11

CS100 & C100 models
• Cold air is drawn in through the inlet vent and gap provided by the door
buffers.
• Warm air is exhausted through vent tray.
• Inlet vent is mounted over cupboard side, door or
floor cut-out (see below).
• Observe 100mm inlet / outlet vent separation (see below).
The vent tray must be fitted. It provides a safe exhaust for
!
refrigerant gas in the unlikely event of a leak.
Vent tray
4mm door buffers
(supplied)
Vent tray dimensions WxDxH (mm): 500 x (515-555) x 40
Quick Start Installation Guide
807120NZ v1.00 01.21 G5 C CS Quick Start Guide
SECTION 6: Set up the ventilation
100mm
Air outlet
Air inlet
11