Table of Contents
Advertisement
Lighting, windscreen wipers and washers ›
Operating conditions
✓ The turn signal is switched on or the front wheels
are steered sharply.
✓ The low beam is switched on.
✓ The fog lights are not switched on.
✓ The driving speed is lower than 40 km/h.
Function COMING HOME, LEAVING
HOME
Functionality
Version 1
Applies to vehicles with automatic driving light
switch function.
The COMING HOME function turns on the light after
turning off the ignition and opening the driver's door
automatically. The light switches off automatically
after the set lighting time has elapsed.
The LEAVING HOME function switches on the light
when unlocking the vehicle with the wireless remote
control automatically.
Version 2
Applies to vehicles without automatic driving light
switch function.
The COMING HOME function turns on the light after
turning off the ignition, manually activating the func-
tion and opening the driver's door. The light switches
off automatically after a few seconds.
The LEAVING HOME function switches on the light
when unlocking the vehicle with the wireless remote
control automatically.
Operating conditions
Version 1
Applies to vehicles with automatic driving light
switch function.
✓ Visibility has worsened.
✓ The light switch is in the
Version 2
Applies to vehicles without automatic driving light
switch function.
✓ The light switch is in the
Operation
Activate COMING HOME function manually
Applies to vehicles without automatic driving light
switch function.
›
Switch off the ignition.
position.
position.
Function COMING HOME, LEAVING HOME
›
Briefly hold the left lever under the steering wheel
in position
(switching on the headlight flash-
er).
›
Open the driver door.
Settings
This function is set in the following menu in the Info-
tainment system:
Applies to the 10
" Infotainment system:
settings
Replace light bulbs
What you should be mindful of
DIY replacement of the following bulbs is possible.
Have the remaining light sources replaced by a spe-
cialist garage.
The new bulb must conform to the specification of
the original light bulb. The name of the bulb is
marked on the bulb socket.
After changing a bulb in the low beam light, the main
beam or fog light, have the headlights adjusted by a
specialist garage.
CAUTION
Halogen lamps are pressurised and can burst during
replacement!
Wear gloves and safety goggles.
▶
NOTICE
Contamination of the halogen lamp reduces the life
of the lamp!
Do not touch the glass of the light bulb with your
▶
bare fingers.
NOTICE
Danger of headlight damage due to the ingress of
water and dirt!
Always fit the protective cap on the headlight cor-
▶
rectly after changing a bulb.
Conditions for changing a bulb
✓ Ignition off
✓ Light switched off
35
Car Lights
Advertisement
Table of Contents
