Table of Contents
Advertisement
24 DECLARATIONS OF CONFORMITY
1 This device must not cause interference.
2 This device must be able to absorb any interference, including interference that potentially causes undesir-
able operation of the device.
Note on radio transmissions
This device corresponds to the FCC limit values for radiation exposure, which have been determined for a non-
controlled environment, and fulfills the FCC guidelines for the load from radio frequencies.
The transmitter must not be set up near to other antennas or transmitters or operated in conjunction with other
antennas or transmitters.
Note on digital devices of Class B according to the FCC regulations
This device has been tested and fulfills the limit values for digital devices of Class B according to the FCC regula-
tions, Part 15.
These limit values are designed so as to provide sufficient protection from harmful interference in residential
areas.
Devices of this type generate and use high frequencies and can also emit these. Therefore, if they are not
installed and operated in accordance with the instructions, they may cause harmful interference to radio
reception. However, there is no guarantee that interference will not occur in certain cases of application.
Should this device cause harmful interference to radio or television reception, (check this by switching the device
on and off), you can potentially eliminate this interference as follows:
–
Re-align the receiving antenna.
–
Increase the separation between device and radio receiver.
–
Connect the device and the radio receiver to separate electric circuits.
–
Consult your dealer or a radio/TV technician.
CAN ICES‑3 (B) / NMB‑3 (B)
This digital device of Class B fulfills the regulations in accordance with the Canadian Interference-Causing Equip-
ment Standard ICES‑003 / NMB‑003.
388
Advertisement
Table of Contents
